5. PreScan Source
Reads all blocks on the source drive to confirm no I/O errors are encoun- tered.
6. ReScan BUS
Manually scans all ports and reports how many units were found.
7. Source Size
Examines the source drive and reports total space and space used, if drive contains compatible partitions. Press up/down to change display, ESC to exit.
8. Secure Erase
Scans all ports, then erases all data on all connected drives.
NOTE: some drives will remain in a locked state when the process is complete. Drives that are locked may not appear to an operating system and will cause an I/O error if used as a target in the duplicator. If this happens, start secure erase again and hold ESC to cancel the operation a few moments after it begins.
9. Overwrite
Overwrite is used to write data onto the entire hard disk, it will destroy all data on all HDDs connected to the duplicator (including Source HDD) by writing data to all sectors. There are 4
10. Setup
Enters the Setup menu. See Setup Options.
11. View Log
Shows the results from the most recent drive operation, such as copy, overwrite, etc.
12. Adv Setup
Enters the Advanced Setup Menu. Only available by holding ESC on any Main Menu option. See Advanced Setup Options.
www.addonics.com
Technical Support | Phone: | Email: www.addonics.com/support/query/ |
