Addonics Technologies Mobile DVDR/RW manual Serial ATA Cable Installation

Serial ATA Cable Installation

Attach the USB-IDE cable’s “MC 36 Connector” to your Addonics Mobile Drive firm and securely – you should not be able to disconnect the cable without pressing the release notch.

Serial ATA Combo Hard Drive Installation

For Win98SE, Me, 2000 and XP

Note: There no drivers needed to use the Serial ATA cable as long as the drivers are installed for the Serial ATA Controller card/chip. It is plug and play.

1.Make sure the Serial ATA cable is securely attach to the back of the drive. (For Addonics Pocket drives such as Pocket CDROM, Exdrive etc. you may attach the USB connector to the USB port of the computer to provide power for the pocket drives). May vary from system’s USB port power output.

2.Make sure that power is attach to the drive and turned on.

3.Power on the system or you may hot plug while system is on.

4.On the Window Desktop, double click on the MY COMPUTER icon.

5.Plug the Serial ATA connector into your computer’s Serial ATA port.

6.Wait for a few seconds, your computer may blink for a moment as well. Double Click on the “My Computer” icon if not open yet.

You are now ready to use the drive.

Addonics Technologies – Mobile DVD±R/RW Users Guide v 1.0 13