
Installation (RAID)
The Cipher hardware prevents the use of software to configure or manage the Port Multiplier. Configuring a RAID mode must be done using the dipswitches and SET button on the port multiplier itself, located inside the unit at the rear of the chassis.
SET Button | Dipswitch |
|
Installation
1.Use the provided key to unlock the front door if needed and open it.
2.Insert a drive into each bay as desired, SATA connectors first, label side up as shown, then press the drive firmly into place.
3.Connect the Host eSATA cable to a computer. If desired, connect an exter- nal eSATA drive to the Drive eSATA connector.
4.Make sure the AC input switch is set correctly, then connect the power cord to an AC outlet.
5.Insert the Cipher Key into the Cipher
Keyhole.
6.Set the AC power switch on the rear to ON, then press the power button behind the front door to turn on the unit.
7.After the unit has been powered up, the Cipher Key may be removed.
To remove a drive, pull the Eject Lever until the drive disengages from the internal connector then pull the drive out.
Port Multiplier Modes
The Port Multiplier supports several types of RAID and some
www.addonics.com
Technical Support | Phone: | Email: www.addonics.com/support/query/ |