ADDONICS TECHNOLOGIES
Model: RT54S2HMEU
4.While holding the RAID setting button, turn on the HPM and SATA hard drives and continue to hold button for at least 5 seconds.
Note: | The onboard LED's for the eSATA and USB will start blinking |
| while holding down the raid setting button. Once the raid |
| setting button is released, the PM Health LED will blink |
| times. |
| If the PM Health LED stops blinking, the raid set is set |
| correctly. If the PM Health LED lights up as solid green, it is a |
| bad setup. You need to repeat setting up the raid again. |
Instruction for Special RAID Modes:
BIG 2 - 2 Drives Spanned
o Note: Do not connect more than 2 SATA drives to the hardware port multiplier. Doing so will hang the system when you configure the raid.
oFor SATA drives with different capacities, the hardware port multiplier will use the smallest drive capacity of the 2 drives connected to create the total partition size.
FAST 2 - 2 Drives Striped
oNote: Do not connect more than 2 SATA drives to the hardware port multiplier. Doing so will hang the system when you configure the raid.
Verify RAID Setting on the HPM
Note: Disconnect the HPM from host when verifying the RAID setting.
It is assumed that you have already connected the SATA drives and set up the raid mode when verifying the raid setting.
1.Turn on the power for RAID V.
2.Push the RAID setting button with the tool provided. Using the table below, verify if the LEDs are lighting up. The selected LEDs will light up for 2 seconds followed by a blink and cycles back.
RAID Mode | LEDs |
|
|
BIG 2 | LEDs 1, 2 & 3 all OFF |
BIG 4 | 1 ON, 2 & 3 OFF |
FAST 2 | 3 ON, 1 & 2 OFF |
FAST 4 | 2 ON, 1 & 3 OFF |
SAFE FAST | 1 & 3 ON, 2 OFF |
SAFE 2 | 1 & 2 ON, 3 OFF |
RAID 5 | 2 & 3 ON, 1 OFF |
RAID 5 + S | 1, 2 & 3 all ON |
LED number is per HPM mounted
TECHNICAL SUPPORT
Phone: | |
Hours: | 8:30 am - 6:00 pm PST |
Email: | http://www.addonics.com/support/query/ |
