Addonics
T E C H N O L O G I E S
Zebra Blu Ray & DVD±R/RW Writer
with eSATA and USB interface
ZBW-10LS2EU
User’s Guide
FCC Warning Statement
This equipment has been tested and found to comply with the limits for a class B digital device pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy. If not installed and used in accordance with the instructions, it may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If the equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment on and off, the user is encouraged to try and correct the interference by one or more of the following suggestions.
Reorient or relocate the receiving antenna
Increase the distance between the equipment and the receiver
Connect the equipment to a different power outlet other than the one where receiver is connected
Consult a certified television or radio technician
Enclosure Overview
Drive Activity LED |
|
Eject Button | Power LED |
Rear View
Fan | Switch USB Port | ||
Screw 2 |
|
| Screw 1 |
|
| ||
|
| ||
Power | eSATA Port |
| |
Connector |
|
Hardware Installation
1.Connect the power adapter to the power connector located at the back of the enclosure.
2.Connect the data cable using
a.eSATA connection
Note: You should have configured the eSATA host controller on your system before you connect the writer. Once the eSATA host controller is configured, do the following steps below.
b.Or USB2.0 connection
Attach the USB cable to the USB port on the enclosure and in your system.
