Addtron Technology 9258 If the IP Power is connected to your Local Area Network (LAN):

_____________________________________________________________________________

IP POWER PAGE 11 OF 24

Type the IP address of the IP Power into your web browser’s address field to access the IP Power

control web pages. The username is admin and the default password is 12345678. Enter these

credentials, or the password you have set. Click OK to enter the IP Power control web pages.

Control the power supply of the outlets

Select the Set Power from the left hand menu.

IP Power 9258 can control 4 outputs individually or at the same time. You can choose to power

off and power on an outlet. You may also set the time to delay before performing the chosen

action under Timer, by entering the time to delay in seconds and selecting On.

Querying the power state of the outlets

_____________________________________________________________________________

IP POWER PAGE 12 OF 24

Click Set Power again to refresh the status. The state of each power outlet is displayed under the

Control column.

System settings with browser

You may set the password, IP address, e-mail address, timer setting, perform an online firmware

update, and set the time of the IP Power through the IP Power control web pages.

Setting the password for IP Power

Select Change password from the left hand menu. The default password 12345678. You may

can change it to a password of your choosing (no longer than 8 characters). Click Apply to save

the change.

NOTE

If you lose or forget the admin password, enter the username super user at the log in webpage

and then click OK. Then turn the power off for a few seconds before turning the power back on.

The IP Power will to be reset to using the default password of 12345678. Note: There is space

between super and user.

Setting the IP Power’s IP address

Select Setup from the left hand menu. Fill in the new IP Address, Subnet Mask, Default Gateway,

and DNS server address. If your network has a DHCP server automatically allocating network

settings, you may choose to enable the IP Power’s DHP Client. The Beeper sound may also be

enabled or disabled on this page.

 If the IP Power is connected to your Local Area Network (LAN):

You may set a fixed IP address or have it automatically assigned by a DHCP server. It is

suggested that you use a fixed IP address so that it is always known.