AC 12 10 8 6 MAN final 3/2/05 12:55 PM Page 8
TIPS BEFORE INSTALLATION
Your Room Air Conditioner unit is designed to
be highly efficient and save energy. Follow these recommendations for greater efficiency.
1. | Select the thermostat setting that suits your |
comfort needs and leave the thermostat at | |
that chosen setting. | |
2. | The filter is very efficient in removing airborne |
NOTE: Save the shipping carton and packing materials for future storage or transport of the unit. Please check the contents of hardware kit against the corresponding model check list, prior to installation of the unit. See lists below.(Fig.A)
Fig. A Installation Hardware
particles. Keep air filter clean. Normally, filter |
should be cleaned once a month. More |
frequent cleaning may be necessary depending |
on outdoor and indoor air quality. |
3. Use drapes, curtains, or shades to keep |
direct sunlight from heating your room, but |
DO NOT obstruct the air conditioner. Allow air to |
circulate around the unit without obstructions. |
4. Start your air conditioner before outdoor |
air becomes hot and uncomfortable. This avoids an initial period of discomfort while the unit is cooling off the room.
5.When outdoor temperature is cool enough, use HIGH or LOW FAN only. This circulates indoor air, providing some cooling comfort, and utilizes less electricity than when operating on a cooling setting.
! CAUTION !
To avoid installation/operating difficulties, read the instructions thoroughly.
3/8"Screws (4)
1"Screws (2)
7/16" Screws(2)
Support platform(1)
Speed clips(2)
Support angles (1)
Top channel(1)
Factory installed
Bottom bar(1)
Factory installed
Top retainer (1)
Foam (1)
Nuts(2)
Washers(2)
End Cap & Leveling Leg (1)
Filler panel(1)
Side channels(2)
Factory installed
Sliders(2)
Shorter seal (1)
Seals (2)
Side seals (2)
Factory installed
Your Room Air Conditioner was designed for
easy installation in a vertical (slider type) windows. NOTE: This unit is NOT designed for single
or
NOTE: Surplus screw(s) for spare use.
Tools Needed for Window Installation
Screw drivers: Both Philips and flat head
Power drill: 1/8 inch diameter drill bit Pencil
Measuring tape Scissors Carpenters level
6