Operating Your System

ARMING

Before the control can be armed, all of the intrusion zones must be secure as
indicated by the green READY indicator. If the READY indicator is off, one or
more zones are faulted. The indicator(s) corresponding to the faulted zone(s) will
light. Use the pull out zone I.D. card on the control station to determine the areas of
protection which are assigned to each of the six (6) zones, thencheckthe appropriate
doors and windows to see that they are closed.
1.
Verify that the
READY
indicator is on.
2. Enter your User Code.
3.
The control station will begin beeping and the red ARMED indicator will blink
to indicate that arming will take place after the exit time expires. (The ARMED
indicator will light steady after the system arms).
4. Leave the building immediately.
The control is programmed with an exit delay time which allows a specific amount
of time to leave through any delay defined intrusion detection zone without causing
an alarm. Be sure that you have been informed on routes to enter and exit from
without causing an alarm. If too much time is taken to exit, the beeping tone will
change to a steady tone, indicating the start of entry delay. Disarm the control and
start over to avoid a false alarm.
Your security system is divided into two areas of protection:
1.
2.
PERIMETER-Thefirstlineofdefense. Consistsofoneormorezoneswhich
detect intrusion through doors and windows.
INTERIOR
-
The
backup or second line of defense. Consists of one or more
zones that detect intruders that have already entered the building. Interior
detection devices usually consist of motion detection devices, interior door
contacts, and under carpet sensors, designed to surprise
the
intruder.
prior to arming the control, you may first choose to turn off the interior protection,
allowing free movement within the building when armed.
3