Security Codes (cont’d)
- 30 -
Quick Arming
Note that if Quick Arming was programmed by the installer, you can
press the # key in place of the security code when arming the
system. You must always use the security code to disarm the system,
however.
To Add a User or Change a User's Code
Important: Temporary users of the system (e.g., babysitter, cleaning staff)
should not be shown how to use any system function they do not need to know,
such as bypassing protection zones.
You must make sequential key depressions for all steps in a
procedure within 2 seconds of one another (e.g., perform steps 1, 2,
and 3 below with no delay between steps), or else the entire entry is
aborted and must be repeated from its beginning.
1. + 8
(Master Code)
Enter 4-digit Master code, then press
the 8 key.
Example: Press 2 0 5 9 then 8
2.
(User Number)
Enter user number.
Enter the 2-digit user number (03-16) for
the user you are adding or changing.
3.
(User's Code)
Enter user's code.
Enter the new 4-digit security code for
that user.
Changing the Master Code
Follow the procedure for changing a user's code, but enter user 02.
Additionally, when changing the Master code, you must perform step
3 twice with the same user code entry so that the new Master code
will be accepted by the system.