®
Quick Start Guide
| For more detailed documentation, visit us online at www.adtran.com. |
NetVanta 3100 Series Router | P/N 1700600L2, 1700610L2 |
|
|
NetVanta 3120
|
|
|
|
| SWITCH |
|
|
STAT | ETH1 | VPN | DBU | 1 | 2 | 3 | 4 |
|
NetVanta 3120 Front Panel Layout
NetVanta 3130
|
|
|
|
| SWITCH |
|
|
STAT | WAN | VPN | DBU | 1 | 2 | 3 | 4 |
|
NetVanta 3130 Front Panel Layout
GETTING STARTED
Two configuration methods are available for your NetVanta router:
•
•AOS Command Line Interface (CLI)
The GUI lets you configure the main unit settings and provides online guidance and explanations for each setting. However, using the AOS CLI may be necessary for more advanced configurations.
ACCESS THE GUI
You may access the
1.Connect the router to your PC using one of the four switch ports on the back of the unit.
2.During bootup your PC will obtain an IP address from the NetVanta 3100 Series unit’s DHCP server. By default, both the DHCP and HTTP servers are enabled.
3.Enter the unit’s IP address in your browser address line. The default IP address is 10.10.10.1.
4.You will then be prompted for the username and password (the default settings are admin and password).
5.The initial GUI screen appears.
6.Click on Getting Started in the System menu on the left side of your screen and follow the
For security purposes, you should set up an admin password immediately. Use the Passwords page of the Web GUI to change this password.
By default, the NetVanta 3130 comes with an ADSL and an Asynchronous Transfer Mode (ATM) port already configured and enabled. The service provider should provide a PVC (VPI/VCI) number which will be used to configure the ATM PVC.
CONFIGURE THE ATM PVC (NETVANTA 3130 ONLY)
1.Click on the Getting Started link under the System menu. This brings up a side bar page.
2.Click on Step 1 - Configure the Public Interface at the top of the side bar page to open the ATM PVC page.
3.Enter the PVC number and select an Interface Mode. Usually this is PPP or PPPoE; however, if IP routing is chosen, you will need to enter an IP address.
4.Click Apply. If PPP or PPPoE is selected as the Interface Mode, you will be taken to the PPP page after clicking Apply. Here you will need to select the type of authentication needed, authentication passwords, and the Address Type. In most cases you will want the Address Type to be Negotiated. Click Apply when all the information is complete.
ACCESS THE CLI
If needed, you can access the AOS CLI via a Telnet session.
1.Telnet to the unit’s IP address. The default IP address is 10.10.10.1.
2.You will then be prompted for the username and password (the default settings are admin and password).
3.Enter enable at the > prompt.
4.Enter the enable password when prompted. The default password is password.
uy
Quick Start Guide, | Technical Support | Copyright © 2006 ADTRAN, All Rights Reserved |
