ADTRAN 61175044L2-22B warranty Jobaid, Ac/Dc Power Supply And Battery Charger, Status Leds

JOBAID

AC/DC POWER SUPPLY AND BATTERY CHARGER	PRICING AN D AVAILA BILITY	800	.827.0887
	RETURN FO R R EPAIR	256	.963.8722
	TECHNICAL SUPPOR T	888	.4ADTRAN
	61175044L2-22B

AC/DC POWER

SUPPLY AND BATTERY CHARGERP/N: 1175043L1

CLEI: SIMPAAAARA

P/N: 1175043L2

CLEI: SIMPAADARA

P/N: 1175043L3

CLEI: SIMPAAEARA

Note: The AC/DC Power Supply

and Battery Charger is

designed for use with the

Total Access 750 and 850.

	MOUNTING INSTRUCTIONS
1	Remove the Total Access 750/850 AC/DC Power Supply
	(ADTRAN P/N 1175043Lx) from the box and inspect for
	damage. If damage is apparent, contact your carrier or
	supplier.

2 Place the power supply with the power cord oriented downward.

3 Use four #6 x 3/8" machine screws (supplied) to mount the power supply to either side of the Total Access 750/850 shelf.

Note: Threaded mounting holes are provided on both sides of the shelf.

Note: For battery backup installations, it is recommended to mount the power supply on the left side of the Total Access 750/850 shelf, next to the battery cover hinge.

Note: Alternatively, the power supply can be mounted to the backboard with four #6 x 1" wood screws (not supplied).

STATUS LEDS

AC Power Operation (AC power only)		Battery Operation (AC power supply or battery backup)
GREEN	OK	GREEN	OK (charging)
YELLOW	Power Fail	YELLOW	Discharging
RED	Power Fail	RED	Low (<-40 V)
OFF	Power Fail	OFF	Disconnected

RELAYS

Alarm Relay

■Provided for customer use

Condition	Alarm Relay
Normal	Open
AC Power Failure/	Cycles open/closed once per second if AC voltage <88 Vrms at full load and battery
Battery Backup engaged	backup is connected
Battery voltage <-45V	Stays closed if voltage <-45 VDC to indicate that battery is becoming depleted

Battery Disconnect Relay

■Disconnects battery pack from the system if the battery voltage falls below -40 VDC

■Prevents damage to batteries

It is not used with the Total Access 612/616/624 units.

CIRCUIT BREAKER

C A U T I O N !

SUBJECT TO ELECTROSTATIC DAMAGE

OR DECREASE IN RELIABILITY.

HANDLING PRECAUTIONS REQUIRED.

The device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Changes or modifications not expressly approved by ADTRAN could void the user's authority to operate this equipment.

WARRANTY

Warranty for Carrier Network products manufactured by ADTRAN and supplied under Buyer's order for use in the U.S. is ten (10) years. For a complete copy of ADTRAN's U.S. Carrier Networks Equipment Warranty: (877) 457-5007, Document 414.

■3- amp circuit breaker

■Protects unit from over - current

■Rocker button extends out from front panel when tripped

■Reset by pushing in on the rocker button

GROUNDING

■An 18 AWG or larger ground wire is required to connect additional ground connector to "ground bus" in customer equipment room.

ELECTRICAL SPECIFICATIONS		TELECOMMUNICATIONS CODES
■	AC input: 115 V nominal
			Code	Input	Output
■ Range: 90 to 132 VAC
			PC	F	C
■	DC output: -54 V, 60 W average, 100 W peak
			TC	—	—
■	Battery charging: 16 hr nominal, 24 hr maximum
				E	—
			IC

■ Battery discharge: Up to 8 hours

JOBAid, 61175044L2-22B, December 2002 Technical Support 1-888-4ADTRAN (1-888-423-8726) Copyright  2002 ADTRAN, All Rights Reserved