The connector pinout for the Single-Wide FT1 Repeater is shown in Figure 2.
1 | GND |
2 | NC | |
3 | T | CUSTOMER |
4 | R | LOOP 1 |
5 | T | NETWORK |
6 | R | LOOP 1 |
7 | NC | |
8 | NC | |
9 | NC | |
10 | GND |
11 | NC | |
12 | NC | |
Figure 2. ADTRAN Single-Wide FT1 Repeater
Connector Pinout
Revision History
This is the first issue of this practice. In subsequent issues, revisions will be summarized in this paragraph.
2. INSTALLATION
CAUTION
This equipment contains static-sensitive components. Be sure to follow proper electrostatic discharge procedures before handling or installing the equipment.
The Single-Wide FT1 Repeater circuit pack is shipped in a separate carton and must be installed in an environmental apparatus case.
Remove the Single-Wide FT1 Repeater circuit pack from the carton and visually ensure that damage has not occurred during shipping or handling. If damage has occurred, file a claim immediately with the carrier, then contact ADTRAN customer service.
The Single-Wide FT1 Repeater circuit pack is designed for installation in a pre-wired apparatus case. These are described in Table B.
Table B. FT1 Repeater Apparatus Cases
ADTRAN | | |
Part | | FT1 |
Number | Description | Repeaters |
1150027L1 ... | 4-Slot, Dual T1 form, air | ........ 4 |
1150027L2 ... | 4-slot, Dual T1 form, gel | ........ 4 |
1152010L3 ... | 2-slot, Dual T1 form, gel | ........ 2 |
1152010L4 ... | 2-slot, Dual T1 form, air | ......... 2 |
1150057L1 ... | 4-slot, Universal, air | 4 |
1150057L2 ... | 4-slot, Universal, gel | 4 |
1150058L1 ... | 8-slot, Universal, air | 6 |
1150058L2 ... | 8-slot, Universal, gel | 6 |
3.INSTALLATION OF SINGLE-WIDE FT1 REPEATERS IN ADTRAN APPARATUS CASES
When installing the Single-Wide FT1 Repeater in an ADTRAN apparatus case, refer to the ADTRAN Installation/Maintenance practice for the apparatus case being used.
CAUTION
The housing must be considered to be under pressure and should be handled accordingly. The Single-Wide FT1 Repeater dissipates a maximum of 3 watts.
