ADTRAN T-BR1TE specifications Product Specifications, Ordering Information

CORPORATE OFFICE

901 Explorer Boulevard Huntsville, AL 35806

8009ADTRAN Local: 256 963-8000 Fax: 256 963-8699

Fax Back: 256 963-8200 http://www.adtran.com email: info@adtran.com

TELCO TECHNICAL SUPPORT

800 726-8663

REGIONAL OFFICES

Irvine, CA 800 788-5408

Denver, CO 800 471-8651

Atlanta, GA 800 332-6945

Kansas City, KS

800 471-8649

Philadelphia, PA

800 471-8656

Dallas, TX 800 471-8648

Canada 800 232-6811

ADTRAN is an ISO 9001 registered company.

Printed in U.S.A. on recycled paper 61100.019L1-8F May 1998 ©ADTRAN, Inc. 1998

Product Specifications

LOOP INTERFACE

■Line: 4-wire (Tx and Rx pair)

■Operating Mode: Full-duplex

■Data Rate: 192 kbps total; 144 kbps available to customer

■Signal Format: Alternate Mark Inversion, 100% pulse width

■Output Amplitude: 0.75 volt, zero-to-peak

■Tx Source Impedance: Per ANSI T1.605-1992

■Rx Source Impedance: Per ANSI T1.605-1992

■Receiver Sensitivity: Per ANSI T1.605-1992

DS1 FACILITY INTERFACE

■Fully compatible with WECO D4 channel bank equipment

NETWORK COMPATIBILITY

■Interface: ISDN and other digital service

FACEPLATE CONTROLS AND INDICATORS

■Controls: B1/B2, LP/CR, Select, Test

■Indicators: Four-character display is used to select loopback address and display loopback status

■Test: Bantam test jacks for TPI 108/109 RT II or equivalent test sets

MECHANICAL

■Size: 4.4" H, 10" D, 1.4" W

■Weight: 10 oz

■Mounting: Mounts in WECO D4 channel bank, SLC-96 terminals, ADTRAN ACT and BR1/8 BR1TE Bank

POWER

■–48V:250 mA, 1.35 watts dissipation (when supplying a maximum of 12 watts to terminal equipment)

■+12V: 45 mA nominal

■–12V: 1 mA

■5V:

—10 mA Display OFF

—45 mA Display ON

Ordering Information

EQUIPMENT	PART #
T-BR1TE	1100019L1
BR1/8 BR1TE Bank	1150018L1

Specifications subject to change without notice.