Installation
Positioning
Install the machine on a flat hard floor.
Make sure that air circulation around the machine is not impeded by carpets, rugs etc.
•Before placing it on small tiles, apply a rubber coating.
•Never try to correct any unevenness in the floor by putting pieces of wood, cardboard or similar materials under the machine.
•If it is impossible to avoid positioning the machine next to a gas cooker or
•The machine must not be installed in rooms where the temperature can drop below 0.
•The water inlet hose and the drain hose must not be kinked.
•Please ensure that when the appliance is installed, it is easily accessi- ble for the engineer in the event of a breakdown.
Levelling
Carefully level by screwing the adjustable feet in or out. Never place cardboard, wood or similar materials under the machine to compensate for any unevenness in the floor.
Water inlet
Connect the water inlet hose to a separate tap with a 3/4" thread.
The inlet hose is provided with a water stop device, which protects against damage caused by water leaks in the hose which could develop due to natural ageing of the hose. This fault is shown by a red sector in the window “A”. Should this occur, turn the water tap off and refer to your Service Cen- tre to replace the hose.
The other end of the inlet hose which con- nects to the machine can be turned in any direction. Simply loosen the fitting, rotate the hose and retighten the fitting, making sure there are no water leaks.
A
47
