AEG 1576 T Door reversal, Fitting a door panel, Unscrewing the screws, Height, Maximum thickness

Door reversal

The opening direction of the outer door on this machine can be rever- sed. To carry out this operation, proceed as follows:

Disengage the end of the		6
catch (1) from the door
	7	2
and turn it 90° to		5
remove it from its seat
(Fig. A).

Using a screwdriver, turn
plastic plug (2) 90° to	8		4
remove it from its seat
(Fig. A).
Fit plug (2) in the hole	P0534	1 9 3
left free by catch (1) and
turn it 90° to lock it in			1
place (Fig. B).	5		7
Fit catch (1) into the		6
hole from which plug (2)
was removed and turn it
90°, making sure that	2
the latching tooth is fac-			8
	4
ing towards the right
(Fig. B).
Remove the door by	P0535	3 9
unscrewing the screws
securing it to the bottom hinge (3 - Fig. A).

Unscrew the two plastic screws (4 - Fig. A) and fit them on the oppo- site side (4 - Fig. B).

Remove the catch hook (5 - Fig. A) by inserting a screwdriver into the upper hole and pushing downwards.

Remove plate (6) by inserting a screwdriver into the bottom hole and pushing upwards (Fig. A).

Refit the catch hook (5) and plate (6) on the opposite sides (Fig. B).

10)Remove the door catch (7) and plate (8) as explained in paragraph

7.

Turn the door 180°.

Refit the door catch (7) and plate (8), reversing their position and pressing firmly to engage the hook (Fig. B).

Fit the door onto the machine. Insert the top pin first, then the bot- tom pin into the hinge (3- Fig. B); finally screw the hinge onto the washing machine.

50

Check that the door is aligned with the appliance. To do this, loosen screw (9 - Fig. B) by a couple of turns and re-tighten when alignment is correct.

Fit the flexible end of the door catch (1 - Fig. B) into the location provided in the door.

Fitting a door panel

The door of this machine has mouldings to allow fitting of a decorati- ve panel (stainless steel sheet, laminated plastic, wood etc.) to match with the existing kitchen units.

The dimensions of the panel must be as follows:

Width	588 mm
Height	588 mm
Maximum thickness	004 mm

To fit the panel, remove the moulding by unscrewing its fixing screws. Position the panel, then refit the moulding, making sure that it comes into contact with and firmly clamps the panel.

51