AEG 1576 T Detergent dispenser drawer, Before the first wash

Detergent dispenser drawer

Compartment for prewash or soak detergent and stain remover. The prewash

or soak detergent is added at the beginning of the wash programme. The

stain remover is added during the STAIN-Action phase in the main wash.

Compartment for powder or liquid detergent used for main wash.

It is emptied at the beginning of the wash cycle.

Compartment for liquid additives (fabric softener, starch).

It is emptied at the last rinse.

The quantity of additives must not exceed the “MAX” mark in the

drawer.

Before the first wash

Before your first wash, we recommend that you run a cotton cycle at

60°C, without any laundry in the machine, to remove any manufac-

turing residue from the drum and tub.

Pour 1/2 a measure of detergent into the dispenser drawer and start the

machine.

Programme chart

To cancel a programme which is running, turn the programme selector

dial to the ANULACION (RESET)position: three flashing dashes will be

displayed.

Warning! After a programme which ends with water in the drum

(RINSE HOLD option), turn the selector dial first to ANULACION

(RESET)and then to the PUMP OUT programme.

To alter a programme, first set the machine to PAUSE by pressing the

START/PAUSE button.

Before the machine starts the heating phase, i.e. within the first 15

minutes for cotton programmes, 10 minutes for synthetic and delicate

programmes and 5 minutes for the wool programme, the selected wash

cycle can be modified.

Warning! If the programme selector dial is turned first to ANULACION

(RESET)and then to the new programme, the programme which is running

is cancelled, the water is emptied out and the machine re-starts from

water filling. To simply modify the programme which is running, turn

the programme selector dial to the desired position (avoiding the RESET

position): when the START/PAUSE button is pressed again, the machine

restarts with the newly selected programme from the point at which it was

interrupted.

The door can only be opened before the machine starts the heating

phase (within the first 15, 10 or 5 minutes, depending on the pro-

gramme selected - see paragraph above) and during the rinse phase.

Set the machine to PAUSE (by pressing the START/PAUSE button).

If the door does not open, this means that the machine is already heat-

ing, or that the water level is above the bottom edge of the door.

This prevents water from spilling out when the door is opened.

Description of the appliance Description of the appliance