58
The four feet of the appliance are
pre-adjusted.
Large degrees of unevenness can be
compensated for by individually ad-
justing the height adjustable screw
feet.
Use the special spanner supplied to
do this.
Important! Do not use pieces of
wood, cardboard or such like to lev-
el out unevenness in the floor, but
adjust the height adjustable screw
feet instead.
Electrical connection
Details about the voltage, type of supply and the fuses required are to
be found on the rating plate. The rating plate is next to the doorway.
Connecting to the water supply
Important!
•This appliance must not be connected to the hot water system.
•When connecting it, use only new hose kits.
•Only connect the appliance to the drinking water supply. Rain water
or water for industrial use may only be used if it fulfils the require-
ments of DIN1986 and DIN1988.
•Do not kink or crush the water inlet hose or drain hose.

Permitted water pressure

The wa ter pr essu re mus t be a t leas t 1 bar (= 10 N/cm 2=0.1MPa) and may
be a maximum of 10bar (=100N/cm2=1MPa).
–If more than 10 bar: Connect a pressure reductio n valve.
–If less than 1bar: Disconnect the appliance end of the inlet hose from
the solenoid inlet valve and remove the flow meter. (In addition re-
move the filter using pointed pliers and take out the rubber gasket
behind it.) Re-insert the filter.