11
Wall mounting●Fix the drilling template to the wall.
●Make 3 Ø 8mm holes in the wall 2 at points I, 1 as desired at
points L.
●Insert the three Ø 8mm expansion plugs into the wall.
●Insert 2 5x45 screws at points I but do not tighten them
completely.
●Adjust the unit so that it is positioned at a right angle to the wall
by turning the two support screws G.
●Fit the hood into holes I, tighten the 2 screws.
●From inside the hood, insert the third 5x45 screw into hole L.
Fig. 5
5