AEG 2842-6 I Starting up and temperature regulation, Instructions for building-in

Models: 2842-6 I

1 14
Download 14 pages 50.79 Kb
Page 7
Image 7
Instructions for building-in

Instructions for building-in

Starting up and temperature regulation

Wash the inside of the appliance with lukewarm water with a little bicarbonate of soda added (5ml to 0,5 litre of water). Do not use soap or detergent as the smell may linger. Dry the appliance thoroughly.

Apply joint the sealing strip as shown in figure.

Push appliance into the hous- ing until stop strip (A) touches the kitchen unit.

D765

A

D023

When the refrigerator compartment door is opened, the internal ligh- ting is switched on. The temperature selector knob is located on the RH side of the refrigerator compartment.

Setting “0”: Off.

Setting “1”: Hightest temperature, (warmest setting).

Setting “6” (end-stop) :Lowest temperature, (coldest setting).

The exact setting should be chosen keeping in mind that the tempe- rature inside the refrigerator depends on:

-the quantity of food stored

-how often the door is opened

The temperatures in the refrigerator compartment and freezer com- partment cannot be independently regulated.

If you want to freeze fresh food rapidly, select setting “6”, ensuring that the temperature in the refrigerator compartment does not drop below 0°C. You should also promptly reset the temperature regulator to set- ting “3” or “4”, if this occurs.

Important!

High ambient temperatures (e.g. on hot summer days) and a cold set- ting on the temperature regulator (position"5" to "6") can cause the compressor to run continuously.

If this happens, turn the temperature regulator back to a warmer set- ting (position "3" to "4"). At this setting the compressor will be switched on and off as usual and automatic defrosting recommenced.

Open the door and push the appliance against the side of the kitchen unit opposite to that of appliance hinges.

Fasten the appliance with 4 screws provided in the kit included with the appliance. Snap vent grille (C) and hinge cover (D) into position.

 

D

D723

C

Ambient Temperature switch

With a room temperature below +16°C the Fridge free- zer may not function correctly. If the room temperature is lower than +16°C it will be necessary to depress switch

(A). The relevant pilot light comes on.

A

D710

22

7

Page 7
Image 7
AEG 2842-6 I Starting up and temperature regulation, Instructions for building-in, Ambient Temperature switch