Operating Instructions
1)(°d) German degree, measure of the hardness of water
2)[mmol/l] millimol per litre, international unit for the hardness of water
3)On this setting the length of the wash programme may be slightly longer. *) factory setting
Setting the water softener
Using the table as a guide, adjust the water softener to that which cor- responds to the hardness of the water in your area:
0The dishwasher must be switched off.
Setting manually:
1.Open the dishwasher door.
2. Remove the lower basket from the dishwasher.
3. Turn the hardness range switch to 0 or 1 (see table).
4.Replace the lower basket.
| Setting electronically: |
| 1. Press the ON/OFF button. |
| The ON/OFF button’s LED will illuminate. |
3 | If other indicators are also illuminated, this means that a wash pro- |
| gramme has been started. The wash programme must be cancelled |
(RESET):
Press function buttons 2 and 3 simultaneously for approx. 2 seconds. All other indicators will go out.
2.Press function buttons 2 and 3 simultaneously and keep them pressed.
The LED indicators for function buttons 1 to 3 will flash.
3.Press function button 1.
The LED indicator for function button 1 will flash.
The LED indicator for the end of the wash programme will flash simul- taneously:
–The number of times that the LED indicator for the end of the wash programme flashes corresponds to the hardness setting.
–This sequence of flashes is repeated many times, with a 3 second pause in between.
4.Pressing function button 1 increases the hardness setting by 1. (Exception: hardness setting 1 follows hardness setting 10).
5.When the hardness setting is correct, press the ON/OFF button. The hardness setting is now saved.
11