| Installation and Connection Instructions |
3 | The following section is only applicable to dishwashers that have a |
| safety valve on the threaded hose fitting for the tap: |
| Water inlet hose with safety valve |
| After connecting the |
| next to the tap. Therefore the water inlet hose is only under pressure |
| while the water is running. If the water inlet hose starts to leak during |
| this operation, the safety valve cuts off the running water and the |
| draining pump in the dishwasher is switched on. |
1 | Please take care when installing the water inlet hose: |
| – The distance between the bottom |
| edge of the safety value and the |
| floor on which the dishwasher is |
| standing must be at least 30 cm: |
| – The electrical cable for the safety |
| valve is in the |
| inlet hose. Do not immerse the |
| water inlet hose or the safety valve |
| in water. |
| – If the water inlet hose or the safety |
| valve is damaged, remove the |
| mains plug immediately. |
| – A water inlet hose with safety valve |
| must only be replaced by a |
| specialist or Customer Services. |
| – Place the water inlet hose in such a way that it is never higher than |
| the bottom edge of the safety valve. |
35
