User information
Symptom | Cause | |
|
|
|
|
|
|
The washing cycle is much | • | the water inlet is blocked, |
too long : | • | there was a power supply failure or the |
|
| water was cut off, |
| • | the motor temperature safety device |
|
| tripped, |
| • | the water inlet temperature is lower |
|
| than normal, |
| • the foam detection safety system trip- | |
|
| ped (too much detergent) and the |
|
| washing machine evacuated the foam, |
| • the | |
|
| tripped, an additional phase was |
|
| added to distribute the washing in the |
|
| drum better. |
The «End»* light ** flashes 4 | • | the cover is not correctly closed. |
times***: |
|
|
The «End»* light ** flashes 2 | • | the drain filter is blocked, |
times***: | • | the drain pipe is blocked or kinked, |
| • the drain pipe is too high (see «instal- | |
|
| lation»), |
| • the drain pump is blocked, | |
| • the installation siphon is blocked. | |
The «End»* light ** flashes 1 | • | the water tap is closed, |
time***: | • | the water network has been cut off. |
The «End»* light** flashes | • | the flaps of the drum door are opened. |
10 times *** |
|
|
|
|
|
*Depending on the model.
**Eliminate the causes of the failure if you find them, and then press on the «Start/Pause» pusbutton to restart the interrupted program.
***Depending on the model, some acoustic signals may be activated.
28