AEG 50212, 50612 If the wash results are not satisfactory, There are grey stains on the washing

Problem	Possible cause	Remedy
		Wait until the	(DOOR) in-
	Door locked.	dicator has gone out and the
		(END) indicator is illumi-
		nated.
The door cannot be		The programme will continue
opened when the wash-		when the power cut is over.
ing machine is switched	There has been a power cut.	To remove washing:
on.	(All indicators are off.)
		If water can be seen in the
	The door will remain locked
		appliance, first drain the wa-
	for approx. 2 minutes.
		ter before opening the door
		(see section ”Carrying out an
		emergency drain”).
Washing is very creased.	Too much washing may	Observe maximum loads.
	have been loaded.

If the wash results are not satisfactory

Washing is grey and scale is being deposited in the drum

•Too little detergent is being used.

•The right detergent was not used.

•Special soiling was not pre-treated.

•Programme or temperature was not correctly set.

There are grey stains on the washing.

•Washing soiled with ointment, grease or oil was washed with too lit- tle detergent.

•It was washed at too low a temperature.

•A common cause is that fabric conditioner – especially a concentrate

– has got onto the washing. Such stains should be washed out as quickly as possible and make sure that you are careful when using fabric conditioner.

After the last rinse foam can still be seen.

•Modern detergents may create foam even in the last rinse cycle. The washing is however sufficiently rinsed.

There are white residues on the washing.

•This is due to the insoluble ingredients in modern detergents. They are not caused by insufficient rinsing.

Shake or brush the washing. If possible turn the washing inside out before washing. Check your choice of detergent. Especially with dark colours it is advisable to use liquid detergents.

21