1.Open the porthole and extract the inlet hose.
2.Connect the hose with the angled connection to the machine.
Important!
Do not place the inlet hose down- wards. Angle the hose to the left or right depending on the position of your water tap.
3. Set the hose correctly by loosening the ring nut. After positioning the inlet hose, be sure to tighten the ring nut again to prevent leaks.
4.Connect the hose to a tap with a 3/4” thread.
Always use the hose supplied with the appliance.
Installation should comply with local water authority and building regula- tions’ requirements.
A minimum water pressure of 0.05 MPa (0.5 bar) is required for safe op-
eration of the appliance.
If you cannot make the cold water
connection direct from the rising mains, you may be able to operate the appliance from your cold water storage system.
There should be a minimum distance of 5.02m (16.5 ft) between the appliance’s inlet and the bottom of the water storage tank.
Aqua Control
The inlet hose is provided with a wa- ter stop device, which protects against damage caused by water leaks in the hose which could devel- op due to natural ageing of the hose. This fault is shown by a red sector in the window „A”. Should this occur, turn the water tap off and re- fer to your Service Centre to replace the hose.
31
