AEG 5 operating instructions What do I do, if, Special accessories

What do I do, if ...

... it is difficult to push the nozzle

Reduce the power setting on the appliance. This will not reduce cleaning efficiency.

... the motor thermal cut-out is activated

If the motor is overloaded, e.g. due to a full filter bag or blocked accessory, the thermal cut- out shuts down the motor. In this case, switch off the appliance, unplug from the mains, and leave the motor to cool down.

Check paper filter bag, suction tube and suction hose; remove any blockage.

The appliance can be switched on again after approximately 30 minutes.

... the fuse has blown

The fuse may blow if you use other electrical appliances with high power consumption on the same electric circuit at the same time as the vacuum cleaner is in use.

This can be avoided if you set the electronic power adjuster to the lowest power level and then select a higher level after switching the appliance on.

Your vacuum cleaner can be fitted with a gentle startup control which reduces the starting current to the motor and therefore prevents the electric circuit cut-out being triggered under normal conditions. It is possible that there will be a delay of about 4 seconds in the appliance starting up on the lowest power level.

... the paper filter is damaged at some point and the motor protection filter becomes dirty Remove motor protection filter, clean (shake out) and replace.

Insert new paper filter.

Special accessories

Turbo-brush

The turbo-brush makes the care of carpets and hard floors easier. The rotary motion, of its brush gently loosens shortpille carpets where the dirt has been trodden in.

Special nozzle

For use on parquet tiled and, hard floors.

13