AEG 6524gm-m B - Cooking Instructions, Automatic start-upwithout valves, Using the burners, Power

B - Cooking Instructions

Automatic start-up without valves

Turn the corresponding knob anti-clockwise up to the maximum position (Large flame, Fig. 1) and press start-up button (fig. 1).

Automatic start-up with valves

Turn the corresponding knob anticlockwise up to the maximum position (large flame, fig. 1) and press the knob. Once the burner has been started up, keep the knob pressed for about 6 seconds.

Using the burners

In order to obtain the maximum yield without wasting gas, it is important that the diameter of the pot is suitable for the burner potential (see the following table). This is to avoid the flame extremities being larger than the base of the pot.

All of the operating positions must be chosen between the maximum and the minimum ones, never between the minimum position and the closing point.

The gas supply can be interrupted by turning the knob clockwise up to the closing position.

NOTE: If there is no power supply, it is possible to light the burners with matches, setting the knob to the start-up point (large flame, fig. 1).

BURNERS	POWER	POWER
	(MJ/h)	(Btu/h)	Ø Of Pots
Auxiliary	3.6	3415	10 - 14 cm
Semi-rapid	6.3	5976	16 - 18 cm
Rapid	10.8	10245	20 - 22 cm
Wok	13.7	12977	24 - 26 cm

NOTE: When the equipment is switch off, always check that the knobs are in the closing position. If the flame should blow out accidentally, the safety valve will automatically stop the gas supply, after a few seconds. To restore operation, set the knob to the lighting point (large flame, fig. 1) and press. While cooking with fat or oil, pay the utmost attention as these substances can catch fire when overheated.

WARNING:

•Do not use sprays near the appliance in operation.

•Do not place unstable or deformed pots on the burner, so as to prevent them from overturning or overflowing.

•Always turn gas off if moving a pot away from the appliance.

4