AEG 72850 What to do if…, Age» section, Drain filter is clogged Clean the drain filter, Spin

		What to do if…
			29
Problem		Possible cause/Solution
	The end of the drain hose is too low.
The machine fills then empties immediately:	•	Refer to relevant paragraph in «Water drain-
		age» section.
	The drain hose is squashed or kinked.
	•	Check the drain hose connection.
	The drain filter is clogged.
	• Clean the drain filter.
The machine does not empty and/or does not	An option or a programme that ends with the
	water still in the tub or a that eliminates all the
spin:	spinning phases has been selected.
	•	Select the draining or the spinning pro-
		gramme.
	The laundry is not evenly distributed in the
	drum.
	•	Redistribute the laundry.
	Too much detergent or unsuitable detergent
	(creates too much foam) has been used.
	•	Reduce the detergent quantity or use anoth-
		er one.
	Check whether there are any leaks from one of
	the inlet hose fittings. It is not always easy to
	see this as the water runs down the hose; check
There is water on the floor:	to see if it is damp.
	•	Check the water inlet hose connection.
	The drain or the inlet hose is damaged.
	•	Replace it with a new one.
	The cap on the filter has not been replaced or
	the filter has not been properly screwed in after
	cleaning action.
	• Refit the cap on the filter or screw the filter
		fully in.
	Too little detergent or unsuitable detergent has
	been used.
	•	Increase the detergent quantity or use an-
		other one.
	Stubborn stains have not been treated prior to
	washing.
Unsatisfactory washing results:	•	Use commercial products to treat the stub-
		born stains.
	The correct temperature was not selected.
	•	Check if you have selected the correct tem-
		perature.
	Excessive laundry load.
	•	Reduce the laundry load.