Operating Instructions
Washing cycle is complete/Removing the washing.
Once the washing programme has come to an end, END illuminates on the programme progress display.
If RINSE HOLD was selected, the display beside the START/ PAUSE button flashes.
01. After a rinse hold, the water must first be pumped out:
–Either press the START/PAUSE button (the water is pumped out and the washing is spun according to the completed programme; After the START/PAUSE button is pressed again, the spin speed can still also be changed during spinning),
or
–Turn the programme selector to PUMP OUT and press the START/ PAUSE button (the water is pumped out without spinning),
or
–Turn the programme selector to SPIN or SHORT SPIN and press the
START/PAUSE button (the water is pumped out and the washing is spun or gently spun).
At the end of this programme step, the END indicator will illuminate.
2.Open the door.
As soon as the DOOR indicator lights up green, the door can be opened.
3.Remove the washing.
4.Turn the programme selector to OFF.
5.Close the water tap.
6.After washing, pull out the washing detergent dispenser drawer slightly so that it can dry out. Leave the door ajar so that air can circulate in the drum.
3 | If the OVERDOSING indicator illuminates, then too |
| much detergent was used in the washing programme |
just completed. Observe the dosing recommendations of the detergent manufacturer as well as the load quantity for the next wash.
23
