HINTS AND TIPS
ECOLOGICAL HINTS
•Do not use fabric softener to wash and then dry. In the tumble dryer laundry becomes soft automatically.
•Use the condensate as distilled wa- ter, e.g. for steam ironing. If it is nec- essary clean the condensate before (e.g. with a coffee filter) to remove possible small pieces of fluff.
•Always keep the airflow slots on the bottom of the appliance clear.
•Use the load volumes which are specified in the programmes chapter.
•Make sure that is good airflow in the appliance installation position.
•Clean the primary filter after each drying cycle.
•Clean the heat exchanger filters when the applicable indicator comes into the view on the control panel.
•Spin good the laundry before drying.
AVERAGE LAUNDRY WEIGHTS
bathrobe | 1200 g |
quilt cover | 700 g |
man’s work shirt | 600 g |
man’s pyjamas | 500 g |
sheet | 500 g |
tablecloth | 250 g |
man’s shirt | 200 g |
night dress | 200 g |
pillow case | 200 g |
towelling towel | 200 g |
blouse | 100 g |
ladies’ briefs | 100 g |
men’s underpants | 100 g |
napkin | 100 g |
tea cloth | 100 g |
|
|
ENGLISH 17
WATER HARDNESS AND CONDUCTIVITY
Water hardness can be different for dif- ferent locations. Water hardness has an effect on the water conductivity and the operation of the conductivity sensor in the appliance. If you know the value of the water conductivity you can adjust the sensor to dry with the better results. To change the sensor conductivity:
1.Turn the programme dial to availa- ble programme.
2.Push at the same time the Dry Plus and the Anticrease buttons. Hold down until one of the symbols go into view on the display:
– | low conductivity <300 |
μS/cm
–
moderate conductivity
–
high conductivity >600 μS/cm
3.Push the Start Pause button again and again until you set necessary level.
4.To memorise the setting push at the same time the Dry Plus and the Anticrease buttons.
WATER CONTAINER FULL — INDICATION
By default the indication LED is always on. It comes into the view at the end of the cycle or when the water container is full. When you use an external equip- ment to drain the container, the LED can be off.
To activate or deactivate the indication:
1.Turn the programme dial to availa- ble programme.
2.Push at the same time the Dry Plus and Buzzer buttons and hold down until you see the correct setting:
– the LED is off and the symbol 
goes into the view - The
LED is permanently off
