ENGLISH 29
INSTALLATION
APPLIANCE POSITIONING
•The tumble dryer must be installed in a clean position, where dirt does not collect.
•Air must flow freely around the appli- ance. Make sure that the front airflow slots in the bottom of the appliance are not blocked .
•To keep vibration and noise at the minimum, when the tumble dryer op- erates, it must be put on a stable and flat surface.
•When the appliance is put in its per- manent position, check if is fully level with the aid of a spirit level. If it is not, adjust the feet until it is.
•Do not remove the feet. Do not de- crease the floor clearance through thick carpets, bar of wood or equiva- lent. This can increase the heat which can cause interference with the oper- ation of the appliance.
• The temperature of the hot air which occurs in the tumble dryer can increase to 60 °C. The appliance must not be in- stalled on the floor which is not resistant to high tempera- tures.
•When the tumble dryer oper- ates, the room temperature must not be lower than +5 °C and higher than +35 °C. This can cause unwanted effect on the performance of the appli- ance.
•If it is necessary to move the appliance, it must be moved vertically.
•The appliance must not be in- stalled behind a lockable door, a sliding door, a door with a hinge on the opposite side to that of the appliance in such a way that a full open- ing of the tumble dryer is re- stricted.
It is possible to adjust the height of the tumble dryer. To do that adjust the feet (see picture).
15mm |
UNPACKING |
CAUTION! |
Before use all parts of the transport packaging must be removed.
To remove the polystyrene blockages:
1.Open the load door.
2.Pull 2 plastic hoses with the poly- styrene blockages out from the drum.
x2 |
