Operating Instructions
36
If the washing results are not satisfactory
If the washing has turned grey and if limescale is deposited in the
drum, then
•Too little detergent was used.
•The wrong detergent was used.
•Special soiling was not pre-treated.
•Program or temperature not set correctly.
•If multi-component detergents are used, the individual components
were not used in the correct ratio.
If there are still grey spots on the washing,
•Washing soiled with ointments, grease or oils was washed with too
little detergent.
•Too lower temperature was used for washing.
•A frequent cause is that softener - particularly that in concentrated
form - has reached the washing. Wash out such spots quickly and use
the softener concerned carefully.
If at the end of the last rinse foam is still visible
•Modern detergents can also cause foam in the last rinse. However,
the washing is still sufficiently rinsed.
If there are white remnants on the washing
•These are insoluble components of modern detergents. They are not
the result of an insufficient rinsing effect.
Shake or brush out the washing. In future, perhaps you should turn
the washing inside out before washing it. Examine your choice of de-
tergent and if necessary use liquid detergent.
The rinsing water is
murky.
The cause is probably a de-
tergent with a high silicate
content.
No negative influence on the
rinsing result, use liquid de-
tergent if necessary.
The corresponding dis-
play does not light up
when one of the addi-
tional program but-
tons is pressed.
The selected additional pro-
gram cannot be combined
with the set program.
Make another selection.
Problem Possible Cau se Remedy