Operating Instructions
35
Washing not well spun.
Residual water still vis-
ible in the drum.
Fault code E20 ap-
pears. The indicator
RINSE flashes.
Drainage hose bent. Remove the bend.
Maximum pump head (outlet
head 1m from unit's floor
surface) exceeded.
Consult Customer Service.
They can supply a retrofit kit
as a special accessory for de-
livery heads of more than
1m.
Solution pump blocked.
Switch off the unit and pull
out the mains plug. Clean
the solution pump.
If a siphon is connected: Si-
phon blocked. Clean the siphon.
The main door cannot
be opened while the
appliance is turned on.
The main door is locked be-
cause of a high water level or
a high temperature. The dis-
play DOOR is not lit.
Wait until the display DOOR
lights up green.
Should it nevertheless be
necessary to open the main
door:
Turn the programme knob to
OFF; turn the programme
knob to PUMP OUT. Press
button START/PAUSE. The
main door can be opened af-
ter the water has been
pumped out.
Power fail ure!
(All displays have gone off.)
For safety reasons the door
remains locked for 4 to
5minutes.
If water can be seen through
the window in the door, first
carry out emergency empty-
ing (see section “Carrying out
Emergency Emptying Opera-
tion").
After approx. 4 to 5 minutes
the door can be opened
again by pulling the handle.
Washing detergent
residues form in the
washing detergent
drawer.
Water tap not fully opened. Open the water tap fully.
Filter in the screw connec-
tion of the intake hose on
the water tap or on the unit
is blocked.
Close the water tap. Unscrew
the intake hose from the wa-
ter tap and from the unit.
Clean the filter.
Problem Possible Cau se Remedy