Installation 15
Location
The appliance should be installed well away from sources of heat such as radiators, boilers, direct sunlight etc. Ensure that air can circulate freely around the back of the cabinet.To ensure best
performance, if the appliance is positioned below an overhanging wall unit, the minimum distance
between the top of the cabinet and the wall unit must be at least 100 mm . Ideally, however, the appliance should not be positioned below over-
hanging wall units. Accurate levelling is ensured by one or more adjustable feet at the base of the cabinet. If the cabinet is placed in a corner and
the side with the hinges facing the wall, the dis-
tance between the wall and the cabinet must be at least 10 mm to allow the door to open enough so that the shelves can be removed.
WARNING!
It must be possible to disconnect the appliance from the mains power supply; the plug must therefore be easily accessible after installation.
Door reversibility
To carry out the following operations, we suggest that this be made with another person that will keep a firm hold on the doors of the appliance during the operations.
To change the opening direction of the door, do these steps:
1.Remove the plug from the power socket.
2.Tilt back the appliance carefully so that the compressor cannot touch the floor.
3.Unscrew both adjustable feet.
4.Unscrew the screws of the door bottom hinge.
5.Take off the appliance door by pulling it
slightly downwards.
