Regular cleaning
Never use soap or abrasives for cleaning.
Once is it disconnected from the mains, wash the product with lukewarm water and then wipe it dry.
Use clean water to clean the door sealing gasket.
After the cleaning operations, reconnect the product to the mains.
Once or twice a year it is recommended to remove the dust and dirt from the condenser mounted on the back panel.
GB
If you do not use the product for longer periods, make sure to perform the following:
Switch off the product by pressing the on/off switch until the on/off indicator goes out.
Disconnect the product from the mains. Remove all foods from the product.
Perform defrosting and cleaning operations as described above.
Leave the doors ajar to avoid the
Long-term absence
Problem | Possible causes | Remedial action |
|
|
|
| Thermostat is set too low. | Set to higher position. |
| No sufficient | Provide for sufficient |
| Too large quantity of food inserted: | Cut food into pieces. |
Cooling is too weak. | Too much food inserted for freezing at the same time. | Insert less food. |
| ||
| Food inserted while still hot. | Insert food of room temperature only. |
| Door not fully closed. | Check if door is fully closed. |
Cooling is too strong. | Thermostat is set too high. | Set to lower position. |
|
|
|
No cooling at all. | Plug is not properly inserted into socket. | Check |
| No current in socket. |
|
| According to the indicator, the on/off switch (B) is not | Check presence of current. |
| switched on. | Press the on/off switch (B) for more than a second. |
|
|
|
Noisy operation | Product support is not correct. | Check stability of product support (all four feet |
|
| should stand on floor). |
|
|
|
A rectangular symbol is | Temperature sensor problem | Call the service personnel |
shown on the right |
|
|
side of display "D" |
|
|
|
|
|
In as much as the advice does not lead to result, call your nearest Service Force Centre
Power or operation failure:
In case of power failure during the storage of frozen foods, make sure not to open the freezer door. Once the power failure is over, the yellow indicator (3) of the quick freeze function will light up and then, 5 hours after restart, it will automatically go out.
If a short power failure occurs (max. 13 hours) and the appliance is full, the stored foods will not deteriorate. Otherwise you must use the stored food as soon as possible (if the temperature of the frozen foods rises, their storability will be shorter).
When the electronic system fails to detect the ACTUAL temperature, the alarm indicator will start to flash. The product will continue to operate with the use of a reserve system until the problem is eliminated by the local service personnel.
7
