26Technical data
Removing the oven door
1.Open the oven door as far as it goes.
2.Fully press clamping levers (A) on the two door hinges.
3.Close the oven door until the first posi- tion (angle approximately 70°).
4.Hold of the oven door with one hand on
each side and pull it away from the oven at an up angle.
To install the door follow the procedure in reverse.
The number of glass panels if different for the different models.
CAUTION!
Put the oven door with the outer side down on a soft and level surface to prevent scratch- es.
Removing and cleaning the door glass panels
1.Remove the oven door.
2.Hold the door trim (B) on the top edge
of the door at the two sides and push inwards to release the clip seal.
3. Pull the door trim to the front to re- move it.
4.Hold the door glass panels on their top edge one by one and pull them up out of the guide
5. Clean the door glass panels.
To install panels follow the procedure in re- verse. Install the smaller panel first, then the larger.
TECHNICAL DATA
Voltage
Frequency
50 Hz
