&+(&.,1*23(5$7,212)),5(
Turn on the Gas supply at the meter and to the appliance at the isolating cock. Purge the air to the appliance. Rotate the control knob to the ignition position, depress the control and push the piezo to ignite the pilot. Check that the electrode is sparking between the tip of the thermocouple and continue until a pilot ignition is established. Depress the control knob slightly and rotate
To check the gas pressure at the appliance, allow the coals and the coal bed to cool and turn off the gas supply at the isolating cock. Remove the hexagon headed screw and connect a manometer to the pressure test point, turn on the gas and ignite the fire, allow to heat up and check that the gas pressure is 20 +/- 1 mbar - any appreciable drop may indicate losses through the pipework. The pressure test point may also be used to check for leakage of the joints to the appliance. Allow the coal bed to cool before replacing the screw.
Turn the gas control to the OFF position, wait for 90 seconds, fully depress the gas control, turn to the ignition position and release the control. Attempt to light the pilot with an already prepared match or taper. If the pilot lights the FSD is faulty.
63,//$*(&+(&.
Light the appliance and set to the maximum setting, locate the front and fret in position and leave to warm up for approx. 5 minutes. Check for satisfactory clearance of combustion products by inserting a lighted smoke match on a vertical plane 30mm down, 10mm inside the rear edge of the inner canopy and 70mm from the left hand side of the opening. All the smoke must be drawn into the flue. If spillage occurs, allow a further 10 minutes. Should spillage still occur, examine the chimney for the fault and rectify. The test should be carried out with all windows and doors closed, if an extractor fan is situated in the room, this test should be repeated with the fan running. If there is a connected room with an extractor fan, the test should be repeated with all the doors to that room opened and the extractor fan running.
Demonstrate the lighting and extinguishing procedures to the user.
$'9,6(7+$7
The curing effect of heating the coals will cause an initial odour which, although not harmful, may require additional ventilation until the odour has disappeared.
Any debris or soot is cleaned from the appliance. Advise the customer that they should read their Users Instructions before operating the fire and always follow the advice in the section headed ‘Removal of Debris or Soot Deposits’. The appliance must be serviced annually by a competent person in accordance with these instructions and the appliance is checked for spillage in accordance with the method detailed in these instructions.
Complete the section in the enclosed registration leaflet. Advise that any component part of this appliance be guaranteed against defective workmanship or faulty materials for a period of twelve months from the date of purchase.
Any such part will be replaced free of charge on receipt of the purchasers address at the cost of postage only, provided that:
1.It is accompanied by the registration section cut out of the booklet, together with the original purchase receipt, which will be returned with the replacement part.
2.A competent person has carried out installation, repairs and/or adjustments, such as the supplier’s representative
or a CORGI registered installer.
Page 8
