Operation 13
OPERATION
Ignition of the burner
WARNING!
Be very careful when you use open fire in kitchen environment. Manufacturer decline any responsibility in case misuse of the flame
Always light the burner before you put cookware.
To light the burner:
1.Turn the control knob counterclockwise to the maximum position ( 
) and push it down.
2.Keep the control knob pushed for approximately 5 seconds; this will let thermocouple to warm up. If not, the gas supply will be interrupted.
3.Adjust the flame after it is regular.
If after some tries the burner does not light, check if the crown and its cap are in correct positions.
1
2
3
4
1Burner cap
2Burner crown
3Ignition candle
4Thermocouple
WARNING!
Do not keep the control knob pushed for more than 15 seconds.
If the burner does not light after 15 seconds, release the control knob, turn it into off posi- tion and try to light the burner again after minimum 1 minute.
In the absence of electricity you can ignite the burner without electrical device; in this case approach the burner with a flame, push the relevant knob down and turn it
