Installation
Unpacking
All transit bolts and packing must be removed before using the appli-
ance.
Using a spanner, unscrew and remove the
rear right-hand bolt and lay the machine on
its back, taking care not to squash the hoses.
This can be avoided by placing one of the
corner packing pieces between the machine
and the floor.
Remove the
polystyrene
block from the
bottom of the
machine and
release the two
plastic bags
which are fixed
under the filter
door.
Carefully remove the right-hand bag (1) then the left-hand bag (2) by
pulling them towards the centre of the machine.
Set the machine
upright and
remove the two
remaining bolts
from the back.
Pull out the three
plastic spacers
from the holes into
which the bolts
were fitted.
Plug the open holes with the plugs which you will find in the plastic bag
containing the instruction booklet.
You are advised to keep all transit devices so that they can be refitted if the
machine ever has to be transported again.
39
025
21
132996650.qxd 26/09/01 14.30 Pagina 39 (Nero/Process Black pellicola)