21
107205
OWNER’S MANUAL
For more information, visit www.desatech.com
FIREPLACE
INSTALLATION
Continued
REMOVING/REPLACINGGLASS DOOR
You must remove glass door to install optional
brick liners, logs, lava rock, and ember material.
CAUTION: Do not operate this
fireplace with a broken glass door
panel. Do not operate this fire-
place without the glass door panel
securely in place. For replace-
ment part information see

Re-

placement Parts

, page 30.
1. Remove the upper louver panel by lift-
ing upward and out (see Figure 39).
2. Remove the screws from the three tabs
at the top of the glass door while hold-
ing door securely keeping it from fall-
ing forward.
3. Grasp door by both sides and ease it
upward off of the lower bracket (see
Figure 40).
4. To replace glass door, follow the above
instructions in reverse.
Continued
Figure 40 - Removing/Replacing Glass Door
Figure 39 - Removing Top Louver Panel
Top Louver
Panel
Glass Door
Assembly
Screw
Lower Bracket
for Glass Door
Assembly
INSTALLING OPTIONAL
WALL MOUNT SWITCHGWMS2
NOTICE: The GWMS2 includes
25' of wire for installation. Your
fireplace includes 15' of wire for
accessory installation. Choose the
length that best fits your needs
when installing this accessory.
The installation of a wall switch allows you
to activate the gas control valve and turn the
fireplace on and off. The wall switch is to be
connected to the incoming 120 volt regular
household wiring that supplies electricity to
the fireplace. Refer to wiring diagram on
page 30.
OPTIONAL REMOTECONTROL INSTALLATION(Model WRC)
Note:
If using optional wireless hand-held
remote control, the wall switch must be in
the ON position to be operational. The re-
mote control then becomes the switching
mechanism for fireplace operation.
1. The WRC model receiver does not re-
quire a battery. The receiver can be in-
stalled by first plugging the short ex-
tension cord into the fireplace junction
box. Then plug the receiver unit into
the extension cord. Finally plug the ig-
nition module plug into the receiver
unit (see Figure 41).
Figure 41 - Installing the WRC Remote
Receiver
2. Activate the remote handset battery by
removing the insulating tab on the back
of the handset (see Figure 42). The bat-
tery is included pre-installed.
3. Once the battery is activated the unit is
ready to use.
Junction
Box Remote
Control
Receiver
Extension
Cord Ignition
Module Plug
Figure 42 - Installing Battery into Back of
Handset
Pull to Remove
Insulation Tab
Battery Cover
12 Volt Battery
Back of Handset