AEG L 14840 user manual Stain option by pressing button, Select the Time option by pressing button

16Use

STAIN option by pressing button 5

Select this option to treat heavily soiled or stained laundry with stain remover (extended main wash with time optimised stain action phase).

This option is not available with a temperature lower than 40°C.

Attention! If you wish to perform a programme with the stain option, pour stain remover into compartment . STAIN option is not selectable with a prewash phase.

Select the TIME option by pressing button 6

This option allows you to modify the washing time, automatically proposed by the washer-dryer.

DAILY: by pressing this button once, the corresponding pilot light illuminates and the washing duration will be reduced to wash daily soiled laundry.

SUPER QUICK: by pressing this button twice, the corresponding pilot light remains lit, the washing duration will be reduced to wash lightly soiled laundry or items that have been used or worn for a short time. On the display will be visualized the decreased washing time.

Select an additional rinse (EXTRA RINSE)

This appliance is designed for saving water. However, for people with a very delicate skin (allergic to detergents) it may be necessary to rinse the laundry using an extra quantity of water (extra rinse).

If you wish to activate this option permanently for every washing cycle, depress simoultaneously 2 and 3 for some seconds: the pilot light 10.3 illuminates.

This function stays permanently on. To remove it press the same buttons again until the pilot light 10.3 goes off.

Select the START/PAUSE by pressing button 8

To start the selected programme, press this button, the corresponding red pilot light stops blinking. The pilot light 10.1 or 10.2 is on to indicate that the appliance is operating.

To interrupt a programme which is running, press button 8: the corresponding red pilot light starts blinking.

To restart the programme from the point at which it was interrupted, press button 8 again. If you have chosen a delayed start, the machine will begin the countdown. If an incorrect option is selected, the yellow pilot light of the button 8 blinks for 3 times the message Err is displayed for a few seconds.