|
| ENGLISH 25 |
|
|
|
Problem | Possible cause | Possible solution |
The appliance fills | The end of the drain | Make sure that the drain hose is |
with water and | hose is too low. | in the correct position. |
drain immediately. |
|
|
The washing re- | The detergent you used | Increase the detergent quantity |
sults are not satis- | was not sufficient or cor- | or use a different one. |
factory. | rect. |
|
|
|
|
You did not remove the stubborn stains before you wash the laundry.
Use special products to remove the stubborn stains.
Incorrect temperature | Make sure that you set the cor- |
was set. | rect temperature. |
Too much laundry load. | Decrease the laundry load. |
|
|
After the check, activate the appliance. The programme continues from the point of interruption.
If the problem occurs again, contact the service centre.
If the display shows other alarm codes, contact the service centre.
SERVICE
• Refer to the information supplied with this appliance for guarantee condition and point of contact. The information to give to the service is on the rating plate.
We recommend that you write the in- formation here:
Model..................
(MOD.)
Product number ..................
(PNC)
Serial number..................
(S.N.)
TECHNICAL DATA
Dimensions | Width / Height / Depth | 605 / 850 / 605 mm |
| Total depth | 640 mm |
Electrical connection: | Voltage | 230 V |
| Overall power | 2200 W |
| Fuse | 10 A |
| Frequency | 50 Hz |
Water supply pressure | Minimum | 0,5 bar (0,05 MPa) |
| Maximum | 8 bar (0,8 MPa) |
Water supply 1) |
| Cold water |
