g
gDear Customer,
Please read these instructions carefully. Pay special attention to the safety in- structions on the first pages. Keep the instructions in a safe place for future reference. Give them to any new owners of the appliance.
Description (Figure 1)
ATank
BPouring outlet
CFiller hole with cup (locking)
DLid
EBlade assembly
FRubber seal (in blade assembly)
GMotor housing
H
JSpeed selector
K
LCord storage drawer
(on the bottom of the appliance)
MRating label
(on the bottom of the appliance)
1Safety Instructions
AEG electrical appliances meet the rec- ognised technical and legal standards for safety. As the manufacturers, we nevertheless feel we should bring to your attention the following points on safety.
General Safety
•The appliance should only be con- nected to mains supplies with the same voltage and frequency ratings as those indicated on the Ratings Label.
•Never pull the plug out of the power socket by pulling on the cord.
•Never try to operate the blender if
–the casing has been damaged,
–the cord has been damaged.
•If the power cord for this appliance has been damaged, it should only be replaced, for safety reasons, by the manufacturer or Customer Service, or by a suitably qualified person.
•The appliance should only be repaired by a suitably skilled repair technician. Inappropriate repairs may cause con- siderable safety hazards. If repairs become necessary, contact AEG Cus- tomer Service, or your dealer.
Child Safety
•Do not leave the appliance running while unattended, or let children near the appliance unsupervised!
When operating the appliance:
•Never operate the appliance with your hands bare.
•Plastic parts should never be dried at or near direct sources of heat.
•The appliance must not be used for mixing dyes (paints, or lacquer, etc,).
This can cause explosions!
•When you have finished using the appliance, before cleaning, switch off and pull the plug out of the socket.
•The blade assembly should only be dis- assembled by an authorised technician.
•Never clean the motor casing under running water or soapy water.
•Caution! The blade assembly is very sharp. Be careful when taking the blender apart and
•Do not leave hard objects (for example spoons) in the blade assembly while running, and do not grasp the appli- ance with the hand inside the blender tank. This may cause injury!
•The manufactuer will not be responsi- ble for any damage due to inappropri- ate use or incorrect operation.
10