AEG M 2600 manual Technical Data, Possible applications, Disassembling the Apliance

g

;This appliance meets the following EC guidelines:

•73/23/EWG of 19.02.1973 "Low voltage directive", including Amendment guideline 93/68/EWG

•89/336/EWG vom 03.05.1989 "Electro magnetic compatibility guidelines", including Amendment Guideline 92/31/EWG

Technical Data

Mains voltage: 230/240 V

Power consumption: 600 W

Possible applications

The blender can be used for mixing a wide variety of drinks, crushing ice, reducing fruit and vegetables, whip- ping cream, etc.

Cord storage drawer (Figure 2)

The appliance is fitted with a storage drawer at the bottom. If the connec- tion cord to the power outlet is too long, it can be fed back into the drawer until it is the required length.

Disassembling the Apliance

0Take the plug out of the socket.

0Remove the lid (Figure 1/D).

0Remove the tank (Figure 3).

0Turn the blade assembly counterclock- wise and remove (Figure 4).

0You can now remove the rubber seal (Figure 5).

1Caution! the blade assembly is very sharp. It can cause injury if handled incorrectly! The rubber seal can easily be irreparably damaged by the blade assembly.

Caution! Do not use force when taking the blade assembly out of the blender, as this might cause damage. If neces- sary, tilt it slightly when removing.

Assembling the Blender

0Place the rubber seal on the blade assembly (Figure 5).

0Insert the blade assembly into the tank from the bottom. Turn it clockwise to fasten it (Figure 6). Caution! Handle carefully!

0Seat the tank on the motor casing, ensuring that the two arrows are in alignment with one another (Figure 7).

0Set the lid on the tank.

3The blender will not operate unless the two arrows are correctly aligned with one another (Figure 7). Refer to "Safety System“.

0Insert the filler cup (Figure 1/C), and lock it in.

Operating the Blender

3Place the blender on a level, dry sur- face.

0Open the lid (Figure 1/D) and put all the required ingredients in the tank. Important! Do not exceed the maxi- mum capacity of 1.5 litres.

3You can add other ingredients through the filler hole while the blender is run- ning. You can use the filler cup in the lid to do this (Figure 1/C). Close the filler hole immediately after, to avoid splashing.

0Start the blender by turning the selec- tor (Figure 1/J) to the right, or by pressing the Pulse Button (Figure 1/H).

3We recommend starting with blender Speed 1, then progressing to Speed 2. To crush ice, select Speed 3. The Pulse Button runs the blender at full speed.

0After mixing, first remove the tank (Figure 3), before taking off the lid.

1Do not let the blender run for more than 3 minutes at a time. After run- ning for 3 minutes, the blender should be left to cool for at least 10 minutes.

11