Operating Instructions
22
Washing Cycle Complete/Removing the Washing
The washing program normally ends with the final spin.
After a rinse hold:
After a rinse hold the water must first be pumped out or the washing
spun:
0 1.Release the (RINSE HOLD) button.
2. Either turn the program selector clockwise to position 6 (SPIN),
or position 8 or 11 (SHORT SPIN)
(the washing is spun according to the selected program and
the spin speed set)
or
turn the program selector clockwise to v (PUMP OUT)
(the water is pumped out).
Once the program is finished:
3 For safety reasons, the door remains locked for 1-2 minutes after the
end of the program.
0 1.Open the door.
2. Remove the washing.
3. Press the M (ON/OFF) button.
The indicator extinguishes, the washing machine is switched off.
4. Close the water tap.
5. Pull out the detergent dispenser drawer a little so that it can dry out.
Leave the door ajar for a while. This helps to prevent stagnant smells
and helps to preserve the door seal.
Important! If the washing machine is not to be used for a long period:
close the water tap and isolate the washing machine from the mains.