| Installation Instructions for | ||
| Aga BF Gas Fired Cooker Models | ||
| GC, GCB, GE and GEB | ||
Gas Fired Cookers |
|
| |
| FOR USE IN GB & IE | ||
|
|
| |
PLEASE READ THESE INSTRUCTIONS BEFORE INSTALLING YOUR AGA | |||
|
|
| |
Consumer Protection | Firebricks, Fuel beds, Artificial Fuels - when handling use disposable | ||
As responsible manufacturers we take care to make sure that our | gloves. | ||
products are designed and constructed to meet the required safety | Fire Cement - when handling use disposable gloves. | ||
standards when properly installed and used. | |||
Glues and Sealants - exercise caution - if these are still in liquid form | |||
| |||
IMPORTANT NOTICE: PLEASE READ THE ACCOMPANYING | use face mask and disposable gloves. | ||
Glass Yarn, Mineral Wool, Insulation Pads, Ceramic Fibre, Kerosene | |||
WARRANTY. Any alteration that is not approved by Aga could | |||
invalidate the approval of the appliance, operation of the warranty | Oil - may be harmful if inhaled, may be irritating to skin, eyes, nose | ||
and could affect your statutory rights. | and throat. When handling avoid inhaling and contact with skin or | ||
Important | eyes. Use disposable gloves, | ||
handling wash hands and other exposed parts. When disposing of | |||
This appliance may contain some of the materials that are indicated. | the product, reduce dust with water spray, ensure that parts are | ||
It is the Users/Installers responsibility to ensure that the necessary | securely wrapped. | ||
personal protective clothing is worn when handling, where |
|
| |
applicable, the pertinent parts that contain any of the listed materials |
|
| |
that could be interpreted as being injurious to health and safety, see |
|
| |
below for information. |
|
| |
|
|
| |
INSTALLATION
With specific exceptions, the installing of any type of Aga Cooker is subject to the respective directions contained in current issue of The Building Regulations. In addition, Planning Permission may need to be obtained, which should be applied for separately. The complete range of Aga cookers are suitable for Natural or Propane gases only and cannot be used on any other gas.
The complete cooker is
A minimum clearance of 60mm is required above the raised insulating cover handle.
Side Clearances: A 3mm gap is required each side between the cooker top plate and adjoining work surfaces that maybe fitted, this is to allow for the safe removal of the top plate should this be required at a later date.
Where cookers are fitted against side walls a 116mm clearance is required at the right hand side for oven doors access. (A further 116mm is necessary if a left hand side gas connection is required.
If the Aga is to be installed in a brick recess, then the minimum clearances should be increased by at least 10mm on either side, to allow for the walls not being square and also for the natural dimensional variations found in the castings.
In addition a minimum clearance of 1000mm must be available at the front of the cooker to enable the cooker to be serviced.
NOTE: AGA GAS FIRED COOKERS ARE DELIVERED
Cooker Base or Hearth
It is essential that the base or hearth on which the cooker stands should be level and be capable of supporting the total weight of the respective cooker.
Models GC and GCB 406Kg, GE and GEB - 584Kg.
The top of the hearth must be of
The wall behind the cooker must be of
Tiling
When the cooker is to stand in a recess, or against a wall which is to be tiled, in no circumstances should the tiles overlap the cooker top plate.
Installation Requirements
The installation of the cooker must be in accordance with the relevant requirements of the Gas Safety Regulations, Building Regulations and the bylaws of the local Water Undertaking.
It should be in accordance also with any relevant requirements of the Gas Region and Local Authority.
In you own interest, and that of safety to comply with the law, all gas appliances should be installed by a competent person, in accordance with the relative regulations. Failure to install appliances correctly could lead to prosecution.
On completion, test the gas installation for soundness.
REMEMBER, when replacing a part on this appliance, use only spare parts that you can be assured conform to the safety and performance specification that we require. Do not use reconditioned or copy parts that have not been clearly authorised by AGA.
1 | 03/07 EINS 511056 |
