AGFA 1200 - page 26

Chapter 2: Installing the Scanner 26
If your PC has a 25-pin connector and your Arcus 1200 is the only externa l SCSI device to
be connected to your PC:
" Note: If your configuration also consists of internal SCSI devices and if your SCSI controller
does not disable termination automatically, do not forget to disable the t ermination of the host
adapter. Consult your computer documentation for more information.
1 Set the scanner to an unused SCSI ID number between 0 and 6.
For more information, consult Choosing a SCSI ID Number.
2 Connect the smaller 25-pin end of the SCSI cable to the connector of your PC.
3 Tighten the connector screws to secure the connection.
4 Place the terminator on the 50-pin connector of the scanner.
5 Snap the diamond shaped wire clips into the clip brackets to secure the connec tion.
6 Connect the larger 50-pin end of the SCSI cable to the free side of the term inator. Use the
SCSI cable supplied with the scanner.
7 Snap the diamond shaped wire clips into the clip brackets to secure the connec tion.