AGFA 1200 - page 27

Chapter 2: Installing the Scanner 27
If your PC has a 25-pin connector and your Arcus 1200 will be connected to your PC
together with other external SCSI devices:
If you install the scanner at the end of your SCSI chain:
1 Set the scanner to an unused SCSI ID number between 0 and 6.
For more information, consult Choosing a SCSI ID Number.
2 Remove or switch off the terminator from the last device in the SCSI c hain.
3 Connect the 50-pin end of the SCSI cable to the connector that has becom e available on this
device.
4 Snap the diamond shaped wire clips into the clip brackets to secure the connec tion.
5 Place the terminator on the 50-pin connector of the scanner.
6 Snap the diamond shaped wire clips into the clip brackets to secure the connec tion.
7 Connect the 25-pin end of the SCSI cable to the connector of the scanner.
8 Tighten the connector screws to secure the connection.