Agilent Technologies Firmware Upgrade Kits
Firmware Upgrade Kits
Confirm Required Equipment
This section lists the minimum computer hardware, operating system, and software that are required to perform firmware upgrades on PSG/ESG signal generators.
Computer | IBM compatible PC with a 486 MHz processor or greater |
|
|
RAM Required | 64 MB or more |
|
|
Hard Disk Space Required | 20 MB or more |
| This could increase significantly if a large library of firmware |
| upgrade files are expected to be maintained on the PC. A single |
| firmware release consists of approximately 5 to 8 MB of data. |
|
|
| Use of a |
| used does not have Internet access. |
| Use of a 56 kbps modem is only required for systems downloading |
| firmware updated from the Internet. |
|
|
• If you plan to perform a firmware upgrade using | |
| to the |
| Agilent E44xxB ESG Signal Generators)” on page 6. |
| While making the |
| number |
| serial interface (f) to (f) adapter. |
| • If you plan to perform a firmware upgrade using GPIB, refer |
| to “GPIB Interface Requirements” on page 6. |
| • If you plan to perform a firmware upgrade using LAN, a |
| |
| administrator if problems are encountered. |
|
|
Operating System | Windows XP, 2000, or Windows NT 4.0 (with Service Pack 5 or |
| above) |
|
|
Internet Browser | Use of an Internet Browser is only required for downloading |
| firmware files from the Internet or for viewing firmware release |
| information on your local PC or over the Internet. |
| Microsoft Internet Explorer 4.0 and above, or Netscape Navigator |
| 4.0 and above |
| Either browser must be Java enabled with Java 1.02 or above. |
|
|
6