Agio International 92558 manual Frame Assembly, Coiled Shelf Assembly, Sink Assembly

STEP 4 FRAME ASSEMBLY

Connect right side support frame (Q) and left side support frame (R) using the rear support bar (V). Be sure that the hole in the center of the rear support bar is facing up. Add a 10mm washer (F) to a M10 x 55

mmbolt (A) and insert through the left side frame support(r) into the fixed nuts in the rear support bar (V) as shown in figure 3. Repeat for opposite side. (Q). Attach front support bar to middle support frame as shown in figure 3 using a M6 x 16mm bolt. Tighten with wrench. Do not over tighten. With bottom of rear portion of middle support frame resting on the rear support bar, attach front support bar to right side support frame (with wheels) using M6x 16mm bolt (C) as shown in figure 3. Tighten with wrench. Do not over tighten. Attach middle support frame (W) to the rear support bar (V). Align middle support bar with hole in rear support bar as shown in figure 4. Add a 10mm washer

(F) to an M10 x 55mm bolt (A). Insert bolt through middle support frame and into the fixed nut inside the rear support bar.

STEP 5 COILED SHELF ASSEMBLY

Attach coiled shelf (Y) to right side support frame (Q) and middle support frame (W) using M6 x 16 bolts (C) as shown in figure 4. Position coiled shelf between the right side and middle support frames so that coiled portion of the panel is acing towards the bottom. Insert bolts through the holes from behind the coiled shelf and into the fixed nuts inside the right side and middle support frames. Use hex wrench to tighten completely. Do not over tighten. Attach front panel to left side and middle support panels as shown if figure 4 using M6 x 16mm bolts (C). Insert bolts through holes from behind the front panel into the fixed nuts in the front portion of the left side and middle support frames. Tighten using hex wrench. Do not over tighten.

STEP 6 SINK ASSEMBLY

Install sink drain/stopper assembly (AA) as shown in figure 5. Separate the three pieces and insert the center gasket into the whole in the sink basin. Insert the funnel-shaped portion into the sink drain as shown. From underneath the sink basin, attach the bottom portion of the sink drain/stopper assembly onto the bottom portion of the funnel shaped piece to hold firmly in place.

Figure 3

Figure 4

Figure 5

PAGE 2