STEP 6 SINK ASSEMBLY (continued)
Position the sink top assembly (Z) over the left side, right side and middle support frames, making sure the holes for the bolts are properly aligned. Once in proper position, use M6 x 16mm bolts (C) to attach sink top/basin assembly to the left support frame. Insert bolts through holes in sink top into the fixed nuts in the left side support frame. Repeat procedure for right side support frame. Insert M6 x 50mm bolts (B) through the holes in the middle portion of the sink top/basin assembly through the holes in the middle support frame. Be sure to insert the bolts in the direction towards the right side support frame as shown in figure 6. Add a 6mm washer (E) and an m6 nut to the end of each bolt. Tighten with wrench. Do not over tighten.
STEP 7 FAUCET AND FOLDING COUNTER ASSEMBLY
Attach rear faucet panel (CC) to left side support frame and middle support frame using M6 x 16mm bolts (C). Insert bolts outwards through holes from behind the rear faucet panel and into the fixed nuts in the middle support frame. Repeat procedure for opposite side. Tighten bolts using hex wrench. Tighten completely. Do not over tighten.
Attach the three dowels rods (BB) by snapping into place as shown. Two on left side, one on right side beneath the coiled shelf.
Attach folding counter (DD) to right side of the assembled unit. Position the folding counter between the axle guides on the right side support frame (just below where it meets with the sink top/basin assembly). Slide the folding shelf axle (EE) through the axle guides and through the hollow shaft of the folding shelf. Add 10mm washer to each end of the axle. Secure into place by attaching 10mm end clips (H) to each end of the axle. Attach lower part of front hinge to the front right side support frame as shown in figure7. Attach one end of hinge to threaded post on right side frame and the other end of hinge to threaded post on the underside of the folding shelf. Secure with M6 nut (D). Tighten with wrench. Repeat for remaining hinge. Note: hinge will lock with shelf in the “up” position. Collar on hinge will slide down to lock into position.
Attach faucet (II) to rear faucet panel (CC) by unscrewing plastic gasket and sealer ring from faucet head. Place faucet through hole in rear faucet panel and
Figure 6
Figure 7
PAGE 3
